Fitting Instructions for Universal Rear Seat Covers

For size 06/08 seat covers

1. Remove the base of the rear seat by pulling upwards. Some pressure may be required. A clip under the seat on each side should release. The base can then be removed.
2. Remove the backrest part of the seat by applying upward pressure from the bottom of the backrest and the seat will slide upwards, releasing itself from the clips that hold the backrest in place. The entire backrest will now be able to be removed.
3. Fit the seat cover base to the base of the seat and fasten all straps together for a tight fit.
4. Fit the seat cover backrest to the backrest of the seat and fasten all straps together for a tight fit.
5. Refit the backrest into the vehicle. There should be two hooks protruding from behind where the backrest is to be positioned. Once the backrest is in place apply pressure from the top of the seat in a downwards motion. The backrest will now be secured by the hooks and should hold firmly in place.
6. Refit the base of the seat into the vehicle. Once in place apply pressure to the forward part of the seat base so that it clips back into position. Some pressure may be required.

For size 06H/08H seat covers

1. Remove any headrests from the rear seat. Some headrests have a button located under the headrest. Push the button in and pull the headrest upwards to remove completely. Other vehicles will have a pin that needs to be pushed out to allow the headrest to be removed.
2. Fit the headrest cover over the headrest and fasten the velcro straps together. Do not refit the headrest to the seat just yet, keep on the side.
3. Remove the base of the rear seat by pulling upwards. Some pressure may be required. A clip under the seat on each side should release. The base can then be removed.
4. Remove the backrest part of the seat by applying upward pressure from the bottom of the backrest and the seat will slide upwards, releasing itself from the clips that hold the backrest in place. The entire backrest will now be able to be removed.
5. Fit the seat cover base to the base of the seat and fasten all straps together for a tight fit.
6. Fit the seat cover backrest to the backrest of the seat and fasten all straps together for a tight fit.
7. Refit the backrest into the vehicle. There should be two hooks protruding from behind where the backrest is to be positioned. Once the backrest is in place apply pressure from the top of the seat in a downwards motion. The backrest will now be secured by the hooks and should hold firmly in place.
8. Refit the base of the seat into the vehicle. Once in place apply pressure to the forward part of the seat base so that it clips back into position. Some pressure may be required.
9. Once the back seat is firmly secured refit the headrests into position and  push the headrests down to their full downward position.

WARNING: These seat covers are not suitable for vehicles where airbags are contained within the seat. Do not fit seat covers without side airbag allowance to seats with integrated side airbags.